Visor Lights vs Dash Lights for Emergency Vehicles
Visor lights and dash lights are both interior warning lights, and the difference is where they mount. A visor light straps to the sun visor and flips up out of sight. A dash light sits on the dashboard on a suction cup or tape and usually plugs into the power socket. Pick a visor light when the vehicle has to look ordinary, a dash light when you want the fastest setup, and an interior lightbar when you need warning light across the whole windshield.
Here is how the three compare, what each one draws, and what to check before you mount anything inside the glass.
Visor lights hide, dash lights move, interior lightbars cover the windshield
Visor light
Mounts on the sun visor and folds up flat when it is off, so the car looks unmarked. Good for undercover cars and personal vehicles.
Dash light
Sits on the dashboard against the windshield. Suction-cup mounts move between vehicles in seconds, and most plug into the power socket.
Interior lightbar
A full-width bar along the top of the windshield, or the rear glass, on a bracket made for the vehicle. Hardwired, with room for takedown and alley lights.
Feniex interior lights side by side
Every figure below comes from the product's own page or manual.
| Light | Type | Mount | Power | Colors | Draw |
|---|---|---|---|---|---|
| Interior Visor Light | Visor | Hook-and-loop straps to the visor; permanent kit included | Power-socket plug; cut it off to hardwire | Seven options, including red/blue and amber/white | 0.7 A |
| Fusion 1X | Dash | Suction cup or 3M permanent tape | Power-socket adapter | One color: red, blue, amber, white or green | 1 A |
| Fusion 2X | Dash | Suction cup or 3M permanent tape | Power-socket adapter | Two modules, one color each | 1.5 A |
| Q Series 1X Dash | Dash | Suction cup or 3M permanent tape | Power-socket plug or bare wires | Five-color module | 1 A |
| Q Series 2X Dash | Dash | Suction cup or 3M permanent tape | Power-socket plug or bare wires | Two five-color modules | 2 A |
| Fusion Interior | Interior lightbar | Bracket fitted to the vehicle, front or rear | Hardwired | Eight modules, one color each | 6 A |
| Quantum® Interior | Interior lightbar | Bracket fitted to the vehicle, front or rear | Hardwired | Eight five-color modules | 5 A |
"Power socket" is the 12-volt cigarette-lighter socket. Draw is the maximum current from each product page.
A visor light is the one that disappears
The Interior Visor Light is three-quarters of an inch thin, straps to the sun visor with hook-and-loop fasteners, and its manual says it ships with a cigarette plug. Flip the visor up and the light is gone, which is why undercover units and volunteer firefighters running their own vehicles choose it.
The trade-off is coverage. A visor light shines through the top of the windshield on the driver's side, so it warns traffic ahead, not beside or behind you.
A dash light is the fastest to add and move
A dash light needs no tools: press the suction cup to the glass and plug it in. The Fusion 1X and Fusion 2X come with a suction-cup mount, 3M permanent tape and a built-in shield against back-flash, the glare that bounces off the windshield into the driver's eyes at night.
Pick the module count by how wide you want the light: one module is a single point, two give a wider split such as red on one side and blue on the other. The Q Series dash lights put five colors in every module, so a single unit can match the color rules wherever the vehicle works.
An interior lightbar is for full-time emergency vehicles
Slicktop patrol cars and command vehicles carry their warning light inside the windshield instead of on the roof. An interior lightbar like the Quantum® Interior runs nearly the full width of the glass on a bracket made for that vehicle, is hardwired to the controller, and can add white takedown and alley lights. The Fusion Interior manual warns that a poorly fitted bracket "can cause unnecessary flashback."
It is a bigger install than a visor or dash light, and it draws more: 5 to 6 amps against 0.7 to 2 amps. Plan it with the rest of the vehicle; our guide to emergency vehicle upfitting covers power and wiring.
Check three things before you mount inside the glass
- Airbag zones. The Interior Visor Light manual says not to mount it anywhere that interferes with airbag coverage. Keep every interior light clear of the headliner and pillar airbags.
- Your view of the road. Mount dash lights low and to the side, never in the driver's sightline.
- The colors your state allows. Who may run red, blue or amber inside a vehicle is state law, and many states cap what a personal vehicle may show. Check our 50-state table, and if you volunteer, what your state allows on your own vehicle.
By